I had a good base to work from for this one.

I was wanting the car to look like a lighter two door racing/touring car. The only donor bits I used was the wheels and exchaust. I made up the rest giving some parts a carbon fiber finish. The rear wing was inspired by those they use in the world rally championship.

before:


after:


1214x722

like the chop dude, your doing it very clean. love the kit a lot. just the side vent is too big so it looks weird and the inside is not trough the bg, its still from the original base. other than its nice

thanks mate, I was trying for an agressive look

Hello SHU11Y Do you have a larger version mate? Nice ideas I like the spoiler/carbon fibre boot lid. Not so keen on the enormous air duct. Maybe narrow it up alittle
Watch out for curbs! - Your front wheel doesn't have much tire.

thanks will
have put up a larger version now

Not bad man, Thought I recognized the username from Jdmst.

My C&C would be:
-The carbon texture on the CF parts should be thinner. So make a reallly big CF texture layer, and resize it right down, so you get a finer texture and change the blending mode to say screen or multiply.
-The rear lip looks a bit flat or "toon", Just run the burn tool along the bottom of the lip and it should sort it out. http://img850.imageshack.us/img850/5505/2010wrxstibyshu11y.jpg
-Im not too sure if you used the same Rims donor for both front and rear, but they look really similar, so if that is the case, try to avoid it.

Still, really nice chop and dont usually see too many Aussie artists, so keep up the good work man

Thanks for the pointers there jo, that helps quite a lot.

The wheels are actually not the same. The front is on more of an angle but only sooo slightly

... might see you on the next JDMST meet buddy

most is said , nice job imo , def could be in intermidiate imo